Description
Very clean intake manifold,that has been hand ground to fit the Weber 38/38 carburetor. Removed from a car that was running the 38/38 carb.
Very clean intake manifold,that has been hand ground to fit the Weber 38/38 carburetor. Removed from a car that was running the 38/38 carb.
Weight | 15 lbs |
---|
Purchased for a S14 motor swap 2002. We ended up going a different route for the radiator. The radiator has been stored indoors....
Add to cartA good compromise camshaft for the street. The 292 won't sacrifice too much low end power but increases midrange and will allow your M10 to continue to pull more strongly right up until redline. Lightly used as evidenced by slight polishing from rocker arms. You can't feel any grooves and there is...
Add to cartThis is an unbranded header that was pulled from a project car. Has an O2 bung for monitoring AFRs. If you don't have a wideband O2 sensor you'll need a plug to prevent exhaust leaks. I can cut out a section of exhaust before shipping, but still include the output gasket surface and clamping ri...
Add to cartThis tail panel was cut off a late model car. Has some rust on the inner support pieces as pictured, but the tail panel itself is in great shape. We can ship it on a pallet anywhere in the continental US....
Add to cart2022 Terry Sayther